Part Number Hot Search : 
BA4236L 0402CBBV PE34502 25001 IRLI3215 MUR641CT BA6417F 0505S
Product Description
Full Text Search
 

To Download PCS3I6200AG-06JR Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 February 2008 rev 0.2 Spread Spectrum EMI reduction IC for HD Display
Features
* * * * * * * * *
PCS3P6200A
(EMI) at the clock source, allowing system wide reduction of EMI of all clock dependent signals. PCS3P6200A allows significant system cost savings by reducing the number of circuit board layers, ferrite beads, shielding that are traditionally required to pass EMI regulations. The Supply Voltage of the Device is 3.3V/2.5V. It has two Spread Selection Pins, SS1% and SS2% to select among the four possible deviation options. The Frequency Deviation across the Frequency range remains within 10% of the selected deviation. Refer to the Frequency Deviation Selection Table for details. The Device is available in a 6 Pin TSOT-26 Package, over Commercial and Industrial temperature range.
Custom Clock Generator for Display Systems Wide Operating Frequency Range covering most of the pixel frequencies Generates a low EMI 1x Output Frequency range: 25 MHz - 120 MHz 4 Frequency Deviation selection options 1.50%, 1.25%, 0.75%, 1.00% Supply voltage : 3.3V0.3V 2.5V0.125V ModRate 85KHz @ 72MHz 6 Pin TSOT-26 package Commercial and Industrial Temperature range
Product Description Application
PCS3P6200A is a versatile spread spectrum modulator designed specifically for a wide range of clock PCS3P6200A is targeted for use in a broad range of applications including Liquid Crystal and Plasma Displays frequencies. The device addresses the need of a low EMI clock generator for use in display systems covering wide choice of pixel frequencies. PCS3P6200A reduces electromagnetic interference
Block Diagram
VDD SS2%
SS1%
CLKIN
PLL
ModOUT
VSS
PulseCore Semiconductor Corporation 1715 S. Bascom Ave Suite 200, Campbell, CA 95008 * Tel: 408-879-9077 * Fax: 408-879-9018 www.pulsecoresemi.com
Notice: The information in this document is subject to change without notice.
February 2008 rev 0.2
Pin Configuration (6L TSOT- 26 Package)
PCS3P6200A
CLKIN VSS ModOUT
1 2 3
6
VDD SS2% SS1%
PCS3P6200A
5 4
Pin Description Pin#
1 2 3 4 5 6
Pin Name
CLKIN VSS ModOUT SS1% SS2% VDD
Type
I P O I I P External Reference Clock Input. Ground to entire chip Modulated Frequency Output
Description
Frequency Deviation Selection. Refer to "Frequency Deviation Selection Table" for details. Has an Internal pull-up resistor. Frequency Deviation Selection. Refer to "Frequency Deviation Selection Table" for details. Has an Internal pull-up resistor. Power to entire chip
Frequency Deviation Selection Table SS2%
L L H H
SS1%
L H L H
Frequency Deviation
1.50% 1.25% 0.75% 1.00%
Spread Spectrum EMI reduction IC for HD Display
Notice: The information in this document is subject to change without notice.
2 of 7
February 2008 rev 0.2
Absolute Maximum Ratings Symbol
VDD, VIN TSTG Ts TJ TDV Storage temperature Max. Soldering Temperature (10 sec) Junction Temperature Static Discharge Voltage (As per JEDEC STD22- A114-B)
PCS3P6200A
Parameter
Voltage on any pin with respect to Ground
Rating
-0.5 to +4.6 -65 to +125 260 150 2
Unit
V C C C KV
Note: These are stress ratings only and are not implied for functional use. Exposure to absolute maximum ratings for prolonged periods of time may affect device reliability.
Operating Conditions for 2.5V and 3.3V Supply Voltage Parameter
VDD(2.5) VDD(3.3) TA CL Supply Voltage Operating Temperature (Ambient Temperature) Load Capacitance
Description
Min
2.375 3.0 -40
Max
2.625 3.6 +85 15
Unit
V C pF
DC Electrical Characteristics for 2.5V Supply Symbol
VIL VIH IIL IIH VOL VOH IDD ICC VDD tON CIN ZOUT Input low voltage Input high voltage Input low current Input high current Output low voltage (VDD = 2.5V, IOL = 8 mA) Output high voltage (VDD = 2.5V, IOH = -8 mA) Static supply current* Dynamic supply current (2.5V and no load) Operating voltage Power-up time (first locked cycle after power-up) Input Capacitance Output Impedance 5 40 2.375 11 2.5 2.625 5 1.8 4
Parameter
Min
VSS - 0.3 1.7
Typ
Max
0.7 VDD + 0.3 -35 35 0.6
Unit
V V A A V V mA mA V mS pF
* CLKIN pin is pulled low
Spread Spectrum EMI reduction IC for HD Display
Notice: The information in this document is subject to change without notice.
3 of 7
February 2008 rev 0.2
AC Electrical Characteristics for 2.5V Supply Symbol
CLKIN ModOUT tLH* tHL* tJC tD Input frequency Output frequency Output rise time (measured from 0.7V to 1.7V) Output fall time (measured from 1.7V to 0.7V) Jitter (Cycle to cycle) Output duty cycle 40
PCS3P6200A
Parameter
Min
25 25
Typ
Max
120 120
Unit
MHz MHz nS nS pS
2.2 1.2 250 50 60
%
* tLH and tHL are measured into a capacitive load of 15pF
DC Electrical Characteristics for 3.3V Supply Symbol
VIL VIH IIL IIH VOL VOH IDD ICC VDD tON CIN ZOUT Input low voltage Input high voltage Input low current Input high current Output low voltage (VDD = 3.3V, IOL = 8 mA) Output high voltage (VDD = 3.3V, IOH = -8 mA) Static supply current* Dynamic supply current (3.3V and no load) Operating voltage Power-up time (first locked cycle after power-up) Input Capacitance Output Impedance 5 40 3.0 14 3.3 3.6 5 2.5 4.5
Parameter
Min
VSS - 0.3 2.0
Typ
Max
0.8 VDD + 0.3 -35 35 0.4
Unit
V V A A V V mA mA V mS pF
* CLKIN pin is pulled low
AC Electrical Characteristics for 3.3V Supply Symbol
CLKIN ModOUT tLH* tHL * tJC tD Input frequency Output frequency Output rise time (measured from 0.8 to 2.0V) Output fall time (measured at 2.0V to 0.8V) Jitter (Cycle to cycle) Output duty cycle 45
Parameter
Min
25 25
Typ
Max
120 120
Unit
MHz MHz nS nS pS
1.5 1.1 225 50 55
%
*tLH and tHL are measured into a capacitive load of 15pF
Spread Spectrum EMI reduction IC for HD Display
Notice: The information in this document is subject to change without notice.
4 of 7
February 2008 rev 0.2
Package Information 6L TSOT26
PCS3P6200A
Symbol
A A1 A2 b b1 c D E E1 e e1 L L1 L2 R R1 y
Dimensions Inches Millimeters Min Max Min Max
0.0295 0.00 0.0275 0.0157 0.0118 0.0031 0.1023 0.0590 0.035 0.0039 0.0314 0.0197 0.0157 0.0078 0.1181 0.0069 0.75 0.00 0.70 0.40 0.30 0.08 2.60 1.50 0.90 0.10 0.80 0.50 0.40 0.20 2.90 REF 3.00 1.70 0.95 BSC 1.90 BSC 0.30 0.60 0.60 REF 0.25 BSC 0.10 0.10 0 .... ..... 0.25 8 0.10
0.1141
0.0374 0.0748 0.0118 0.0236 0.0236 REF 0.0098 BSC 0.0039 0.0039 0 .... ..... 0.0098 8 0.0039
Spread Spectrum EMI reduction IC for HD Display
Notice: The information in this document is subject to change without notice.
5 of 7
February 2008 rev 0.2
Ordering Codes Part Number
PCS3P6200AG-06JR PCS3I6200AG-06JR LL = 2 Character LOT #
PCS3P6200A
Marking
AC4LL AC2LL
Package Type
6-Pin TSOT-26, TAPE & REEL, Green 6-Pin TSOT-26, TAPE & REEL, Green
Temperature
Commercial Industrial
Device Ordering Information
PCS3P6200AG-06JR
R = Tape & Reel, T = Tube or Tray O = TSOT23 S = SOIC T = TSSOP A = SSOP V = TVSOP B = BGA Q = QFN DEVICE PIN COUNT F = LEAD FREE AND RoHS COMPLIANT PART G = GREEN PACKAGE, LEAD FREE, and RoHS PART NUMBER X= Automotive I= Industrial P or n/c = Commercial (-40C to +125C) (-40C to +85C) (0C to +70C) 1 = Reserved 2 = Non PLL based 3 = EMI Reduction 4 = DDR support products 5 = STD Zero Delay Buffer 6 = Power Management 7 = Power Management 8 = Power Management 9 = Hi Performance 0 = Reserved U = MSOP E = TQFP L = LQFP U = MSOP P = PDIP D = QSOP X = SC-70 J= TSOT26
PulseCore Semiconductor Mixed Signal Product
Licensed under U.S Patent Nos 5,488,627 and 5,631,921
Spread Spectrum EMI reduction IC for HD Display
Notice: The information in this document is subject to change without notice.
6 of 7
February 2008 rev 0.2
PCS3P6200A
PulseCore Semiconductor Corporation 1715 S. Bascom Ave Suite 200 Campbell, CA 95008 Tel: 408-879-9077 Fax: 408-879-9018 www.pulsecoresemi.com
Copyright (c) PulseCore Semiconductor All Rights Reserved Preliminary Information Part Number: PCS3P6200A Document Version: 0.2
Note: This product utilizes US Patent # 6,646,463 Impedance Emulator Patent issued to PulseCore Semiconductor, dated 11-11-2003 Many PulseCore Semiconductor products are protected by issued patents or by applications for patent
(c) Copyright 2006 PulseCore Semiconductor Corporation. All rights reserved. Our logo and name are trademarks or registered trademarks of PulseCore Semiconductor. All other brand and product names may be the trademarks of their respective companies. PulseCore reserves the right to make changes to this document and its products at any time without notice. PulseCore assumes no responsibility for any errors that may appear in this document. The data contained herein represents PulseCore's best data and/or estimates at the time of issuance. PulseCore reserves the right to change or correct this data at any time, without notice. If the product described herein is under development, significant changes to these specifications are possible. The information in this product data sheet is intended to be general descriptive information for potential customers and users, and is not intended to operate as, or provide, any guarantee or warrantee to any user or customer. PulseCore does not assume any responsibility or liability arising out of the application or use of any product described herein, and disclaims any express or implied warranties related to the sale and/or use of PulseCore products including liability or warranties related to fitness for a particular purpose, merchantability, or infringement of any intellectual property rights, except as express agreed to in PulseCore's Terms and Conditions of Sale (which are available from PulseCore). All sales of PulseCore products are made exclusively according to PulseCore's Terms and Conditions of Sale. The purchase of products from PulseCore does not convey a license under any patent rights, copyrights; mask works rights, trademarks, or any other intellectual property rights of PulseCore or third parties. PulseCore does not authorize its products for use as critical components in life-supporting systems where a malfunction or failure may reasonably be expected to result in significant injury to the user, and the inclusion of PulseCore products in such life-supporting systems implies that the manufacturer assumes all risk of such use and agrees to indemnify PulseCore against all claims arising from such use.
Spread Spectrum EMI reduction IC for HD Display
Notice: The information in this document is subject to change without notice.
7 of 7


▲Up To Search▲   

 
Price & Availability of PCS3I6200AG-06JR

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X